1. Leather Slitter Belts
The surface leather is highly abrasion resistant and the fine leather surface prevents minor scratches on the surface of the steel plate. Medium and high elastic fiber can ensure that the belt provides balanced pressure on the steel plate, the relative motion between the belt and the steel plate is small. The bottom high-strength polyester yarn braided layer has high tensile strength and good toughness, which can meet the needs of high-speed operation; it is also resistant to high temperature and abrasion. High precision of belt size.
2. Dry Slitter Belt
The PU rubber on the surface is very wear-resistant and cut-resistant, which can protect the surface of the belt from scratches and prolong the service life of the belt. The medium and high elastic fiber can ensure that the belt provides balanced pressure on the steel plate, so that the relative motion between the belt and the steel plate is small. The bottom high-strength polyester yarn braided layer has high tensile strength and good toughness, which can meet the needs of high-speed operation; and can resist high temperature and wear. High precision of belt size. Commonly used for drying steel belts.
3. Oil Based Slitter Belt
The surface PU rubber has pattern, good friction, abrasion and cutting resistance, which can protect the surface of the belt from scratches and prolong the service life of the belt. There are holes on the middle surface, which can seep oil. The middle and high elastic fiber has good oil-absorbing performance, which can make the belt provide balanced pressure on the steel plate and make the relative motion between the belt and the steel plate small. The bottom high-strength polyester yarn braided layer has high tensile strength and good toughness, which can meet the needs of high-speed operation; it is also resistant to high temperature and abrasion. High precision of belt size. Commonly used in the slitting of oily steel plate.
4. Felt pads for automatic slitting line machine tension of steel plates
When the steel plate is rolled up after slitting, if the surface of the steel plate is not required to be high, a felt pad is often used to clamp the steel plate, which is both economical and practical.
