Slitting Line Machine shaft inside each roller and the corresponding components are required to unfold the refueling, the same is a Wednesday times. When the air humidity in the production workshop is below 50%, due to the static electricity effect, the warp-supporting car fly start, pressure break off more, the more serious case, a running against the warp worker on the end of a factory silk axle head, to be chemical more than 2 bells and whistles.
We run against the silk fabric slitting warping machine on the modified oiling equipment to deal with the static electricity caused by the beginning of the fly problem, on the same a shaft head only forty-five minutes, not only to ease the labor efficiency of the staff, but also enhance the high efficiency.
Steel Slitting Machine Routine Maintenance:
1. Wipe (pressure wheel, roll out shaft and trauma can not have dirt)
2. When not needed, pay attention to power off.
3. Screws and traumas should be often refueled to prevent rust treatment.
Steel Coil Slitting Machine has to be greased in the area of the left and right knives, three times a week. The clutch area of the feed knife should be lubricated. The threadless extruder screw has to be greased on its drive system shaft and then moved up and down, three times a week. The sealing rolls in the cylinder of the rechargeable battery slitter need to be neatly organized, and the area of the fish eyeballs needs to be lubricated. Rolling bearings and loading frames are oiled once every three days.
In the case of oiling the area of the discharge shaft pin, we need to use a grease gun to start oiling, and before oiling, we need to organize the oiling area first. If the brake pedal connection area to start refueling, after filling the oil to move him back and forth, every week to start three times the moisturizing, but also need to pay attention to the finishing.
If you have another questions, please contact us !
