1. Use the slitting machine to remove the upper knife first, adjust the desired size ( the maximum slitting specification is 300mm), put back the lower knife pressure adjustment knob the middle.
2. Place the upper knife holder lightly to the proper position, lock the fixed handle, push the upper knife until the lower knife is against it, then lock the upper knife and adjust the upper knife pressure knob to make it have pressure.
3. The material to be slit into the feeding shaft and fixed (loose, tight to be appropriate), the material through the drive shaft, pressure wheel, through the upper and lower knife, turn the hand wheel will be brought out, while you can adjust the left and right adjustment knob to make it accurate, and then paste to the paper tube of the roll out shaft, pay special attention to the specifications of the paper tube must be consistent.
4. Turn on the power supply and the counter switch, and adjust the voltage of the roll-out shaft to 5V (normally it is kept at 5V, but it can also be adjusted according to the need).
5. Slitting machine measurement: press the clear key to zero the calculator, the meter P1 for fast, P2 for slow, set P1 less than P2 value "5". After the value is set, the LED will start flashing and stop flashing for about 3 seconds, indicating that the setting is completed.
6. Start the slitting button, adjust the slitting speed knob, send the residual material generated from slitting into the residual material hole on the bottom plate, turn on the blowing switch, and blow the residual material to the trash can.
7. After the slitting is finished, clean up the upper and lower knives and the residual glue on the transmission wheel in time to keep the slitting machine clean.
KINGREAL MACHINERY is a professional manufacturer of material slitting, slitting machinery and its subsidiary machinery and equipment companies, with more than ten years of experience in slitting tools, spacers, slitting, slitting machinery manufacturing experience engineers to ensure the quality of products, Small slitting machine, specializing in copper, aluminum, iron, stainless steel and other kinds of thin strip material slitting with. The highest can reach ≤ 0.002mm, comparable to imported slitting and shearing machines.
